Subject | Text |
Schematic ( Trafo voltage ) Pioneer sx-1700 | I have a Pioneer amplituner but I haven't trafo for this..give me please a schematic or trafo volta |
TFB 286T from monitor Pacкаrd Bell A720 | Does someone know a substitute for the trafo: TFB 286T from monitor Pacкаrd Bell A720. |
|
| Thank you! And one more quastion: how I can get +/-60V on my lenguage I call thet "trafo" :roll: |
Metz ch696G1 dead | Hi,
The set is totally dead. No light in standby led.
I've found some defective components and |
| Start by checking the largest transitors near the flyback trafo (called HOT, used for H-deflection a |
Re: Sony KPS4112 Rear Projection TV circuit diagram (fuse bl | Defently you have an open or sort at the primary of psu
unsolder all the diodes and the resistor of |
Re: TFB 286T from monitor Packard Bell A720, 170ASW, 300ASW | [quote:d2efebf7e1="Leo"]Does someone know a substitute for the trafo: TFB 286T from monitor Pac??rd |
| H!
Duzy, plastykowy umocowany do metalu - w poblizu trafo WN.
wymontuj i sprawdź. |
chassis L6.2AA philips on a 28PT4472/01 | I own the full diagram of this 70cm TV but ... it never starts.everything seems to be OK in the powe |
| Old TV's have often bad solder joints.
Try to gently tap on some components (special the flyback |
| Hello!I have the same amplifier,the trafo is working well(so I can tell you the output voltages),but |
Re: Sharp tv 70DS-03SN, hiccuping PSU | [quote:0f7762c385="torbjorn"] For each pulse, there is a flashover across R820 (1K0 SMD resistor)
|
| 1st item) Because you don't seem to have any high voltage, I'll would start by checking the HOT (lar |
DTV 3-7029 Schneider | I need advice if somebody know?
I replace TDA 4605-2,BUZ90,BYT56K,BUZ73, FLAYBACK TRAFO and all ele |
Metz TV Classic 100hz PIP 693G1 Picture deformation | I have picture problem with my TV.
Somethimes dont show pic only ton works and flyback trafo(HV).I |
help with sony tv kv32fx65 | the tv starts bat after 10 sek. goes to standby and the led is blinking 5 times.
it stands for unst |
| Again a few new questions:
item 1) Do you have high voltage on the CRT? And if so, when turning u |
|
| Hi there,
Have you adjusted the Vg2 pot on the new flyback trafo ?
They are always deliverd wit |